Specifications; Declarations - Levolor Sheer Shadings Manual De Instalación

Ocultar thumbs Ver también para Sheer Shadings:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Additional Information

Specifications

Voltage ................................................................................ 3V
Radio Frequency ........................ 433.92 MHz Bi-directional
Transmitting Power ........................................... 10 milliwatt
Operating Temperature ......... 14°F to 122°F (-10°C to 50°C)
RF Modulation ..................................................................FSK
Lock Function .................................................................... Yes
IP Rating ..........................................................................IP20
Transmission Distance ......................up to 200m (outdoor)

Declarations

U.S. Radio Frequency FCC Compliance
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
( 1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by
one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and
receiver.
•Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician
for help.
Any Changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
Remote Control Guide
16
Home

Publicidad

Tabla de contenido
loading

Tabla de contenido