Troubleshooting - Levolor Sheer Shadings Manual De Instalación

OPERATION

Troubleshooting

Problem Bottom rail does not stop at the top limit.
Check the adjustment position of
both limit stops. The top illustration
shows the correct adjustment. The
limit stop catches the bottom rail,
and the bottom of the limit stop is
slightly above or barely touching
the fabric roll.
In the second illustration, the limit
stop adjustment is too tight. The
fabric may not drop freely and could
even be damaged when the shading
is raised. To correct this, the limit
Solution stop should be adjusted one step
up. Simply pull back on the rear of
the limit stop to adjust its position.
In the bottom illustration, the
adjustment is too loose. The bottom
rail can slip under the limit stop. If
the bottom rail rotates through the
headrail, it must be backed out
before adjusting the limit stop.
IMPORTANT: Both limit stops must
be adjusted to the same position or
else skewing may occur.
Problem Adjacent shadings do not roll up evenly.
It is considered normal if the roll-up on both shadings is within
of each other. If one shading rolls up tighter than another, lower and
raise both shadings several times.
Solution Check that the shading fabric is not catching on any brackets or
components.
Check that the fabric winds evenly and does not rub against the
headrail. If uneven, see "Adjust the Bottom Rail Weight" on page 13.
12
Sheer Shadings Motorized Operating System
Headrail Limit Stop
Headrail Limit Stop
Headrail Limit Stop
Bottom
Rail
Bottom
Rail
Fabric Roll
Bottom
Fabric Roll Rail
Fabric Roll
Pull Back
to Adjust
Pull Back
to Adjust
Pull Back
to Adjust
Too Tight —
Adjust One Step Up
Too Tight —
Adjust One Step Up
Too Tight —
Adjust One Step Up
Pull Back
to Adjust
Pull Back
to Adjust
Pull Back
to Adjust
Too Loose —
Adjust One Step Down
Too Loose —
Adjust One Step Down
Too Loose —
Adjust One Step Down
/ "
5
16
Troubleshooting
The shading raises or lowers unevenly, the fabric rubs against one
Problem
end of the headrail, or the bottom rail is uneven when fully raised.
Check that the window is square by measuring the diagonals.
Check that the installation brackets are level. Shim to level,
if necessary.
Adjust the bottom rail weight. See below.
Adjusting the Bottom Rail Weight
• Release the weight clips by inserting
a flat blade screwdriver into the weight
clip and turning clockwise.
Weight
Clip
Solution
• Move the weight in 1" increments toward the side where the
fabric is gathering.
• Secure the weight clips in position by turning them counterclockwise
after making the adjustment.
• Test and, if necessary, adjust again.
Problem The front fabric appears to cling to the back fabric.
Lightly apply a static spray for home furnishings. Follow the
manufacturer's directions.
Solution Allow the shading to dry in the fully lowered position.
If necessary, reapply the static spray each time the shading is
professionally cleaned.
OPERATION
Weight
Bottom Rail Clip
Weight
Fabric Roll
Gathered
Fabric
Move Weight
Sheer Shadings Motorized Operating System
13