Programming; Getting Started - Levolor Sheer Shadings Manual De Instalación

Programming

Getting Started

During programming, all blinds and shades will jog by
moving slightly down and up. Banded, roller, and sheer
shades will both jog and provide an audible beep.
Certain programming functions will affect all blinds
and shades on the selected channel such as – favorite
position, travel limits, operating mode, and motor speed.
To program an individual blind or shade: pair to its own
channel or put all other shades into sleep mode, or
disconnect blinds from their batteries. Put shades to
sleep by pressing the programming button for 6 seconds
until the motor jogs x 2. Wake shades by pressing the
programming button for less than 1 second.
Select a Channel
Use channel 0 to control all channels together.
Press the
1
channel.
Press the + button on the remote to select a higher
2
channel.
Hide Unused Channels
Select a channel other than 0, then press and hold
1
-
and + buttons simultaneously until remote
the
control displays "C" then "15", then release buttons.
Press the
2
channels needed is shown (between 1 and 15).
Press the   stop button to confirm selection. The
3
screen will display "o" once to confirm selection.
NOTE: Repeat steps 1-3 to unhide channels.
Remote Control Guide
-
button on the remote to select a lower
-
or + buttons until the number of visible
8
Home