Care; Removing The Shading; Cleaning Procedures; Warranty - Levolor Sheer Shadings Manual De Instalación

CARE

Removing the Shading

• Fully raise the shading.
• Move the lever on the installation brackets to the left
to release the shading.
— A flat head screwdriver can be
used to move the lever.
— If the lever is inaccessible or
inoperable, lower the shading
until you can see the underside
of the bracket. Carefully reach
a small flat head screwdriver
behind the shading to the
tab on bottom of the bracket
between the screw holes.
— Push the tab away from the
shading and pull the headrail
to release it from the bracket.
CAUTION: Be very careful to not tear or damage any of the fabric.
• Carefully pull the shading to remove it from the brackets.

Cleaning Procedures

Sheer shadings are made of 100% polyester, which means they are inherently durable
and resilient. However, care must be taken to avoid wrinkling the fabric, particularly
where the vanes meet the facings.
Dusting
• Regular light dusting with a feather duster is all the
cleaning that is needed in most circumstances.
Vacuuming
• Use a low suction, hand-held vacuum for more
thorough dust removal.
Forced Air
• Blow away dirt and debris between the vanes using
clean compressed air.
Spot-Cleaning
• Do NOT spot-clean sheer shadings.
14
Sheer Shadings Motorized Operating System
Top View
Move Lever to Left
Installation Bracket
Tab
End Cap
Underside of
Bracket
Facing
Vanes
Ultrasonic Cleaning
Sheer shadings can be ultrasonically cleaned by a professional with the
exception of light-dimming fabrics.
• Specify that a mild detergent solution be used.
• Never immerse the headrail in the solution.
• Dry the shading completely in the lowered position.
Injection/Extraction
Sheer shadings can be professionally cleaned using the injection/extraction method.
• A dry method of injection/extraction is required for light-dimming fabrics.
• Never immerse the headrail in the solution.
Electrostatic Cleaning
Do not use electrostatic cleaning wipes on any sheer shadings.
A Note About Fabrics
As with all textiles, sheer shading fabrics are subject to some variations. Slight
wrinkling, puckering, or bowing is inherent to this textile product and should
be considered normal, acceptable quality. These characteristics are not usually
visible from the front or rear but may be visible from a side angle.
Precautions should be taken to reduce exposure to harsh environmental
elements, such as salt air. Continuous exposure through open windows and
doors will accelerate the fabric deterioration.
NOTE: Improper cleaning may void warranty.

Warranty

For complete warranty information visit levolor.com or call customer service
at 1-800-538-6567.
Sheer Shadings Motorized Operating System
CARE
15