Care; Removing The Shading; Cleaning Procedures - Levolor Sheer Shadings Manual De Instalación

OPERATION
Troubleshooting
Problem Vanes do not align on side-by-side shadings.
Solution Vane alignment can only be ensured within
are ordered at the same time, at the same height, with the same
color, same operating system and fabric, and when specified on
the order form.
Check that the windows are square and the same height.
Problem The hinge pull tab is not centered on the shade.
Solution • Release the weight clips by inserting a flat head screwdriver
into the weight clip and turning clockwise
• Move the weights along the bottom rail so the hinge pull tab
is free to move
• Slide the hinge pull tab to the desired location on the shade
• Secure the weight clips in position by turning them
counterclockwise after making the adjustment. (See Adjusting
Bottom Rail Weight on page 13.)
14
Cordless Operating System
20-0037-012_Sheer_Shadings_Cordless_F_010621.indd 14-15
/ " when shadings
1
4

Removing the Shading

•
Move the lever on the installation brackets to the left
to release the shading.
— A flat head screwdriver can be used to
move the lever.
IMPORTANT: Be very careful to not tear
or damage any of the fabric.
— If the lever is inaccessible or inoperable,
lower the shading until you can
see the underside of the bracket.
Carefully reach a small flat head
screwdriver behind the shading
to the tab on bottom of the bracket
between the screw holes.
— Push the tab away from the
shading and pull the headrail
to release it from the bracket.
•
Carefully pull the shading to remove
it from the brackets.

Cleaning Procedures

Sheer Shadings are made of 100% polyester, which means they are inherently
durable and resilient. However, care must be taken to avoid wrinkling the fabric,
particularly where the vanes meet the facings.
Dusting
•
Regular light dusting with a feather duster is all the
cleaning that is needed in most circumstances.
Vacuuming
•
Use a low suction, hand-held vacuum for more
thorough dust removal.
Forced Air
•
Blow away dirt and debris between the vanes using
clean compressed air.
Spot-Cleaning
•
Do NOT spot-clean Sheer Shadings.

CARE

Top View
Move Lever to Left
Installation Bracket
Tab
End Cap
Underside of
Bracket
Facing
Vanes
15
Cordless Operating System
1/6/21 4:48 PM