Before You Begin; Mount The Installation Brackets-Outside Mount - Levolor Sheer Shadings Manual De Instalación

INSTALLATION

Before You Begin

Pair Shade Before Installing
REMOTE CONTROL
• Use the – and + buttons to select the
channel to pair to.
Press and hold the programming button
•
on the window covering for about 2
seconds until the shade jogs and/or
beeps once.
• In the next 10 seconds, press and hold
the  on the remote until the shade jogs
twice and/or beeps three times.
USING THE INMOTION APP
• If you purchased a hub, download the LEVOLOR InMotion
• Shade can be directly paired to app, but it is recommended to pair to remote first.
INSIDE MOUNT
Mount the Installation Brackets
• Measure and mark 5" in from each jamb for bracket location.
— If more than two installation brackets come with your order, space additional
bracket(s) evenly between the two end brackets and mark their location.
Mount into wood whenever possible.
TOP VIEW
Jamb
5"
Space Evenly
Limit stops should be equal
distance from the ends of headrail.
• Center the brackets on your marks, then mark the screw hole locations.
— The minimum depth for installation brackets is 1¼".
— The minimum depth for a fully recessed mount is 3½".
6
Sheer Shadings Motorized Operating System
Indicator Light
Programming
Button
Micro-USB Charging Port
™ app to get started.
WINDOW SIDE
Jamb
5"
Space Evenly
Motor
Side
ROOM SIDE
— Mark location for the screws within the slots in the
bracket. The bracket location can be adjusted back or
forth based on the casement depth.
IMPORTANT: The front edges of the installation brackets
must be level and aligned to each other.
CAUTION: Failure to properly align the brackets could result in the
!
headrail releasing from the brackets causing the shading to fall, possibly
resulting in injury or property damage.
• Drill the screw holes using a 3 / " drill bit.
32
IMPORTANT: Use drywall anchors when mounting
into drywall.
• Use a level to check that the mounting surface is level.
Shim the brackets, if necessary.
• Attach the installation brackets using the screws provided.
IMPORTANT: Do not overtighten the screws. Check to ensure the lever can be
moved easily side to side. If not, loosen the screws in one-eighth turn increments
until the lever can be moved easily.
• If using spacer block(s), stack spacer block(s) on
top of the installation brackets. Using #6 Hex Head
Screws, long enough for secure installation (not
provided), install screws up through the underside
of the installation bracket and spacer block(s) into
mounting surface.
IMPORTANT: Do NOT add more than 1 ½". of clearance using the spacer blocks.
OUTSIDE MOUNT
Mount the Installation Brackets
• Center the headrail over the window opening at the desired height. Use a pencil to
lightly mark each end of the headrail.
— Alternatively, measure the width of the headrail and use that width to mark the
headrail end points over the window opening.
• Mark 5" from each end of the headrail.
— If more than two installation brackets came with your order, space additional
bracket(s) evenly between the two end brackets and mark their location.
Mount into wood whenever possible.
INSTALLATION
Sheer Shadings Motorized Operating System
Mounting
Depth
Lever
Spacer
Blocks 1½"
Maximum
7