Mount The Installation Brackets - Side Mount - Levolor Sheer Shadings Manual De Instalación

INSTALLATION
•
Center the installation brackets or extension brackets on your marks and mark
where to drill the screw holes.
— A minimum 1 ⁄ " flat vertical surface is required for the installation brackets.
1
8
Extension brackets require 1
— The tops of the installation brackets or extension brackets should be at the
desired height. The brackets should be level and aligned.
IMPORTANT: The rear of the brackets must be flush against a flat mounting
surface. Do NOT mount brackets on curved molding.
1 / "
1
8
•
Drill the screw holes using a / " drill bit.
3
32
IMPORTANT: Use drywall anchors when mounting into drywall.
•
Attach the installation or extension brackets using the screws provided.
IMPORTANT: The tops of the installation brackets or extension
brackets must be level with their front edges aligned.
8
Cordless Operating System
20-0037-012_Sheer_Shadings_Cordless_F_010621.indd 8-9
1 ⁄ ".
4
Extension
1 / "
1
4
Bracket
•
If using spacer blocks:
— Stack spacer blocks on the backside of
the installation brackets
— Using #6 Hex Head Screws long enough for
secure installation (not provided), install
screws through the installation bracket and
spacer block into mounting surface.
IMPORTANT: Do NOT add more than 1
of clearance using spacer blocks.
IMPORTANT: The tops of the installation
brackets must be level, with the front
edges aligned.
IMPORTANT: Use drywall anchors when
mounting into drywall.
•
If using extension brackets, attach an installation
bracket to the underside of each extension bracket
using the speed nuts and screws provided.
Proceed to "Install the Shading" on page 10.
Side Mount
Mount the Installation Brackets
Side mount the headrail when conventional mounting
techniques will not work — for example, in an arched
window opening.
•
Mount the extension brackets on a surface at
least 1 ⁄ " wide.
1
4
•
Attach the installation brackets to the extension brackets
using the provided screws and speed nuts.
CAUTION: When securing side mounted shadings into a
!
surface other than a secure wall stud, use medium to heavy-duty
wall anchors (not provided). Match anchors to the wall thickness. Failure
to mount the brackets securely may result in injury or property damage.
NOTE: Spacer blocks cannot be used with side mount installations.
Proceed to "Install the Shading" on page 10.
INSTALLATION
Longer
Screw
Spacer
Blocks
⁄ "
1
2
Speed Nuts
Screws
Extension
Bracket
1 / "
1
4
Minimum
Depth
9
Cordless Operating System
1/6/21 4:48 PM