Hach AS950 AWRS Manual De Instrucciones página 13

Figure 6 Multiple bottle installation
1 Retainer for 24 1-L poly bottles
2 Retainer for 24 350-mL glass
bottles
3 Bottle one indicator
5.3 Plumb the sampler
Install the intake tube in the middle of the sample stream (not near the surface or bottom) to make
sure that a representative sample is collected.
1. For a sampler with the standard liquid detector, connect the tubing to the sampler as shown in
Figure 7.
Note: When PTFE-lined tubing is used, use the tubing connection kit for PTFE-lined PE tubing.
2. For a sampler with the optional non-contacting liquid detector, connect the tubing to the sampler
as shown in Figure
Note: When PTFE-lined tubing is used, use the tubing connection kit for PTFE-lined PE tubing.
3. Install the intake tube and strainer in the main stream of the sample source where the water is
turbulent and well-mixed. Refer to
• Make the intake tube as short as possible. Refer to
intake tubing length.
4 Bottle tray for 8 to 24 bottles
5 Slot for bottle tray
6 Front of sampler
8.
Figure 9.
Specifications
7 Removable tray
on page 4 for the minimum
English 13