Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION
• Be sure to push the power cord plug fully into the wall outlet. Also, do not
push it into loose and unstable wall outlets likely to cause a contact failure.
Doing so can result in heat generation.
• Be sure to disconnect the plug from the wall outlet and clean the prongs
and the area around the prongs at least once a year. Allowing dust to build
up on the plug constitutes a fire hazard.
• If you do not use the machine for a long period of time such as consecutive
holidays, be sure to disconnect the power cord plug from the wall outlet for
reasons of safety.
• When performing maintenance on the machine, disconnect the power cord
from the wall outlet for safety.
• Power Source
120–127 V, 3.6 A or more, 60 Hz
Please be sure to connect the power cord to a power source as above.
Requirements during Emergencies
WARNING
• Do not touch this machine if a lightning strike occurs in the immediate
vicinity. Doing so could result in electric shock.
• Be sure to install the machine as close as possible to a wall outlet so that
you can disconnect the power cord plug easily in an emergency.
• If the machine behaves unusually as follows, turn off the power immediately.
After turning off the power, make sure to disconnect the power cord plug
from the wall outlet, and then contact your service representative and report
the problem. Continuously using the power cord can result in fire or electric
shock.
• The machine is emitting smoke
• The machine is emitting odors
• Metal objects or other foreign objects have fallen inside the machine
• Water or other fluids have fallen inside the machine
• If the machine topples or a cover or other part is damaged, turn off the
power immediately. After disconnecting the power cord plug from the wall
outlet, contact your service representative. Using the machine continuously
can result in fire or electric shock.
Requirements for Relocating Machines
CAUTION
• When moving the machine, do not hold the control panel. Doing so may
damage the control panel and can result in injury or malfunction.
• When carrying or moving the machine by lifting it for relocation to another
floor, contact your service representative. Dropping or toppling the machine
can result in injury or malfunction.
• After moving the machine, use the caster fixture to fix it in place. Otherwise,
the machine might move or topple over to cause injury.
• When moving the machine, make sure to unplug the power cord from the
wall outlet and confirm that line cords and other connecting cables have
been removed. Otherwise, the power cord is damaged, possibly resulting in
fire or electric shock.
7
Publicidad
Tabla de contenido
