Transporting The Machine; Before Starting - Stihl FS 85 Manual De Instrucciones

English
up and confine long hair above your
shoulders.
Wear safety boots with steel toe caps
and non-slip soles.
Sturdy shoes with non-slip shoes are permissible
only when using mowing heads.
WARNING
To reduce the risk of eye injuries,
wear close-fitting safety glasses in
accordance with European Standard
EN 166. Make sure the safety
glasses are a snug fit.
Wear face protection and make sure it is a good
fit. Face protection alone is not sufficient to pro‐
tect the eyes.
Wear "personal" sound protection, e.g. ear
defenders.
Wear a safety hard hat for thinning operations,
when working in high scrub and where there is a
danger of head injuries from falling objects.
Wear sturdy protective gloves made
of a resistant material (e. g. leather).
STIHL can supply a comprehensive range of per‐
sonal protective equipment.
2.2

Transporting the machine

52
2 Safety Precautions and Working Techniques
Always stop the engine.
Carry the machine hanging on the harness or by
the shaft so that it is balanced.
To reduce the risk of cut injuries, fit transport
guard on the cutting attachment, even when car‐
rying the tool for short distances – see also
"Transporting the Unit".
Avoid touching hot parts of the
machine and gearbox – risk of burns!
By vehicle: When transporting in a vehicle, prop‐
erly secure your machine to prevent turnover,
damage and fuel spillage.
2.3 Refueling
Gasoline is an extremely flammable
fuel. Keep clear of naked flames. Do
not spill any fuel – do not smoke.
Always shut off the engine before refueling.
Do not fuel a hot engine – fuel may spill and
cause a fire.
Open the fuel cap carefully to allow any pressure
build-up in the tank to release slowly and avoid
fuel spillage.
Only refuel the machine in a well ventilated
place. If fuel has been spilled, immediately clean
the machine – do not allow your clothes to be
splashed with fuel. If that happens, change your
clothes at once.
After refueling, close the fuel cap as
tightly as possible.
This helps reduce the risk of unit vibrations caus‐
ing an incorrectly tightened fuel cap to loosen or
come off and spill quantities of fuel.
Check for leaks. Do not start the engine if there
is a fuel leak – serious or fatal burns could result!
2.4

Before starting

Check that your power tool is properly assem‐
bled and in good condition – refer to appropriate
chapters in the User Manual.
– Check the fuel system for leaks, especially the
visible parts, e. g., fuel cap, hose connections,
manual fuel pump (only in machines with a
manual fuel pump). In case of leakage and
damage, do not start the engine – risk of fire!
Have the machine serviced by a dealer before
using it
0458-393-8721-C