Performing An Emergency Stop; Mounting The Battery Charger - Invacare Reliant 450 Manual Del Usuario

6.1.4 Performing an Emergency Stop

Press the RED button on the control box to stop the lift arms and the patient from raising or lowering.
Rotate the RED stop button clockwise to disengage the emergency stop.

6.2 Mounting the Battery Charger

Refer to your local regulations concerning proper mounting procedures.
1. Place the battery charger with mounting bracket on the wall at the desired position.
2. With a pencil, mark the middle hole position.
3. Measure down 6½ inches from the pencil mark, and drill one mounting hole.
4. Install the bottom mounting screw until there is an approximate 1/8-inch gap between the screw head and the wall.
5. Install the battery charger with mounting bracket onto the bottom mounting screw.
6. Drill the remaining two mounting holes.
7. Install the two remaining mounting screws through the mounting bracket and into the wall. Tighten securely.
1078987-O
Fig. 6-5
6 Operation
29