Replacing The Front Casters; Replacing The Forks - Invacare Reliant 450 Manual Del Usuario

10.8.2 Replacing the Front Casters

1. Place the lift on its side.
2. Remove the bolt and locknut that secure the existing front caster assembly to
the fork.
The front caster assembly consists of two casters and a washer in
between.
The washer will fall out from between the two casters. The washer
can be reused. Examine and replace the washer if it is worn.
3. Position the new or existing washer between the two new casters.
4. Align the mounting holes in the new front caster assembly and the fork.
5. Install the bolt through the fork and the new front caster assembly and tighten
securely with the locknut.

10.8.3 Replacing the Forks

1. Place the lift on its side.
2. Remove the front or rear caster from the lift. Refer to 10.8 Replacing the Casters and Forks, page 58.
3. Unscrew the existing fork from the base.
4. Install the new fork onto the base.
5. Install the front or rear caster onto the lift. Refer to 10.8 Replacing the Casters and Forks, page 58.
1078987-O
10 Maintenance
Fig. 10-7
59