Shark AI360 ROBOT Manual De Instrucciones página 28

LIVING WITH YOUR ROBOT
Questions? For how-to videos, FAQs, troubleshooting, and tips & tricks, visit: sharkclean.eu
CHECK BASE FILL LEVEL
The base is designed to hold weeks of debris. During
initial use, you may have to empty it more frequently
while the robot finds more debris than usual. Check the
fill level regularly to know when to empty.
AVOID MOVING THE ROBOT OR BASE
!
While your robot is cleaning, DO NOT pick it up and
move it, or move the charging base—this will impact
the robot's ability to map your home.
sha rkcl e a n.eu
DOORWAYS AND THRESHOLDS
Your robot can easily climb over most thresholds,
but if one is higher than 2cm, set up a no-go zone in
the app to block it off.
CAN'T CONNECT TO WI-FI?
Restart your phone
• Turn off phone, wait a few minutes, then turn it back on
and connect to Wi-Fi.
Reboot your robot
• Make sure the power switch on the back of the base is
in the ON position.
• Take robot off base and press and hold down the
CLEAN button on the robot for 12 seconds. Turn your
robot back on by placing it on the base.
Reboot your router
• Unplug the router power cable for 30 seconds, then
plug it back in. Allow several minutes for your router to
reboot completely.
• Then follow the steps outlined in the SharkClean® app
Wi-Fi setup instructions.
PREP YOUR HOME
Your robot uses an array of sensors to navigate around walls, furniture legs, and other obstacles while it
cleans. To prevent the robot from entering areas you don't want it to, set up no-go zones in the app. For
best results, prepare your home as indicated below, and schedule a daily cleaning to ensure all floor areas
are regularly maintained.
NOTE: Scheduling is one of many features that can only be done in the app.
OBSTRUCTIONS
Clear cords and remove small
objects like toys, clothing,
or drapes from floors. Open
interior doors in rooms you
want your robot to clean. For
best results, run your robot in
well-lit conditions.
THRESHOLDS
Your robot may have some
trouble clearing thresholds
higher than 2cm. Block off
high thresholds with the
included BotBoundary strips.
STAIRS
For your robot's cliff sensors
to work properly, all runners,
rugs, carpets, or small
thresholds (like child gates)
must be 20cm from any
stairs (or must be continuous
and extend over the edge of
the stairs). If a runner, rug,
carpet, or small threshold
that is less than 20cm from
the stairs cannot be moved,
you must use a no-go zone
or a BotBoundary strip to
block off the stairs.
SCHEDULING
Schedule whole-home
vacuuming runs with the app.
AVOID MOVING THE
ROBOT & BASE
While your robot is cleaning,
!
do not pick it up and move
it, or move the charging
base—this will impact the
robot's navigation and ability
to return to the base when
cleaning is complete.
s ha rkc lea n.eu