Shark AI360 ROBOT Manual De Instrucciones página 33

MAINTENANCE
CAUTION: Turn off power before performing any maintenance.
EMPTYING THE ROBOT DUST BIN
Press the Dust Bin Release Button and slide out the
dust bin.
Empty the debris and dust into bin. Remove filter
and wash dust bin if necessary.
NOTE: Make sure to insert the dust bin completely, until
it clicks into place.
sha rkcl e a n.eu
To open the dust bin lid, press and hold the button
while lifting the lid, using the finger slots.
Look between the filter and the plastic shield and
make sure there is no debris buildup.
Remove shield and clear any debris buildup with a
dry cloth or soft brush.
MAINTENANCE
CLEANING AND REPLACING THE BASE FILTERS
For best results, regularly clean and replace the filters in the base.
To clean filters, rinse with cold water ONLY to prevent damage from cleaning chemicals. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
To open the filter housing lid, hold the top left edge
of the base and pull up on the lid. With the lid open,
remove the foam filter by the top handle, then lift out
the felt filter underneath. Tap the filters clean over the
rubbish bin, then rinse them with cold water ONLY,
as soap may damage them. Allow filters to air-dry
completely before reinstalling them. The filters must
be installed correctly for the base to work properly.
Reinsert the felt filter first, then the foam filter.
NOTE: The pre-motor foam and felt filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.
NOTE: Clean the mesh filter inside the dustbin with a small brush once a month.
Filter
Door
CLEAN POST-MOTOR FILTER EVERY YEAR
Press the button at the top of the Filter Door, then
tilt the door and lift it off. Remove the Post-Motor
Filter from the base by pulling the tab down. Tap
the filters clean over the rubbish bin, then rinse them
with cold water ONLY, as soap may damage them.
To reinstall the post-motor filter, insert it into the
base and replace the filter door.
s ha rkc lea n.eu