Installing Batteries - Gima 32926 Manual Del Usuario

31
*Note!
The above table is not exact for classification of blood pressure and it's intended to be used as a guide in
understanding non-invasive blood pressure measurements.
Usually this is not a cause for concern; however we recommend you consult with your physician for proper
diagnosis or seek medical advice according to our recommendation mentioned above. Please note that the
device does not appropriate to diagnose hypertension, and it is only for user reference on blood pressure
monitoring.
Data Link Function
The monitor is equipped with data link interface to allow user to transfer the blood pressure measurements
to a personal computer via a USB cable. Thus you may easily view and track the data stored in the memory.
Step:
1. Plug USB cable (large connector) into personal computer.
2. Plug USB cable (small connector) into Data Link Port to our monitor.
3. Once USB cable is connected successfully, the monitor will show
"USb" on the screen, indicating that it is ready to transmit data.
*Note!
• Do not allow objects to come into contact with Data Link Port.
• The data cannot be transferred while taking a measurement.
• Do not unplug USB cable or turn off the computer during transmission.
• Unit is exclusively to be connected to equipment that in compliance with the requirements of IEC 60950-1
or IEC 60601-1.

INSTALLING BATTERIES

When LOW BATTERY SYMBOL
play, or nothing appears on the display when the power is
switched on, please change the batteries.
Replace all the batteries with new ones and do not mix
new and old batteries. Do not mix alkaline, standard (car-
bon-zinc) or rechargeable (cadmium) batteries either.
It may shorten the battery life or cause the device to mal-
function.
Remove the battery cover and insert 2 AAA alkaline batter-
ies into the battery compartment as shown.
appears on the dis-
ENGLISH