Before Use; Assembly - Pro HG02354 Instrucciones De Utilización Y De Seguridad

Check that the product is correctly mounted. Prior to every use, check carefully for any
possible damage or loose connections. On no account should you use the product if
there is any damage. Loose connections must be tightened immediately.
Damage to your health cannot be excluded if the device is used improperly.
Do not use the device if you suffer from illnesses, cramps, nausea or chest pains.
Do not use the device during pregnancy.
ATTENTION: Components most susceptible to wear.
Store the device inaccessible when it is not used.
Any of the adjustment devices that could interfere with the user's movement should not
be left projecting.
No more than one user per ring set.
The safety level of the equipment can be maintained only if it is examined regularly for
damage and wear, e.g. the straps, rings and connection points.
To replace defective components immediately and/or keep the equipment out of use
until repair. Only use original replacement parts
To set it up, choose a place that provides enough place for assembly and exercising.
The area chosen should measure at least 2 x 2 m and should be well ventilated. The
subsurface must be level and even. Check that it is has a secure footing.
A free area of not less than 0.6 m shall remain around the training area in the
directions from which the equipment is accessed (see fig. A.).

Before use

Note: Remove all packaging materials from the product.

Assembly

Always test the load bearing capacity of the anchor points in order to ensure that
there are sufficient safety reserves in place. There is a risk of serious injury if this is not
observed.
The minimum loading force of the anchor point is 500 kg
The recommended anchor point, for example, a pull-up system.
Gym rings should be fixed around 50 cm apart to allow for comfortable training.
20 GB/IE