Heiniger Xplorer Pro Traducción Del Manual Original página 35

Malfunction
Clipper cuts badly or
not at all.
Red area visible on
the clipper pressure
display on the adjusting
knob.
Clipper cuts badly or
not at all
Motor does not run or
stops immediately.
Motor does not run or
stops immediately.
Motor runs very slowly. Clipping blades were not oiled
Motor unit becomes
hot.
Running time of a fully
charged battery is too
short and / or blades
are getting hot.
Translation of the original instructions / Cattle and horse clipper
Cause
Clipper blade is blunt
Clipper blades have not been
correctly ground
Clipper blades are not oiled
Clipping pressure too low.
Leaf springs broken.
The animal's hair is wet.
Hairs jammed between top and
bottom blades.
Too much play at the clipper head.
Clipping blades not properly
aligned.
Clipping pressure too strong.
Red area visible on the clipper
pressure display on the adjusting
knob.
Battery is dead.
Contacts dirty.
Faulty battery.
Smell of burning from the motor
housing. Motor burned out.
Clipperhead blocked.
Motor and/or electronics defective. Notify customer service.
sufficiently.
Clipping pressure too strong.
Battery almost discharged.
Motor and/or electronics defective. Notify customer service.
Clipping pressure too strong.
Red area visible on the clipper
pressure display on the adjusting
knob.
Motor faulty.
Clipper blades were not oiled
sufficiently
Flat, not fully charged or faulty
battery is being used.
Rectification
Notify customer service.
Lubricate the clipping blades
every 15 minutes.
Increase the clipping pressure,
as described in chapter 6.6.
Notify customer service.
Only clip dry hair.
Remove the clipping blades;
clean, lubricate and install
them again; set the clipping
pressure.
Notify customer service.
Align the clipping blades cor-
rectly, see Fig. 17.
Reduce the clipping pressure,
as described in chapter 6.6.
Have the blades sharpened.
Charge battery.
Switch clipper off and clean the
contacts.
Replace battery.
Notify customer service.
Remove jamming.
Lubricate the clipping blades.
Reduce the clipping pressure,
as described in chapter 6.6.
Charge battery.
Reduce the clipping pressure,
as described in chapter 6.6.
Notify customer service.
Oil clipper blades.
Only use intact, fully charged
original batteries.
17