Entering Preformatted And User-Defined Traceability Data; Entering The Welder Id Code; Entering Or Changing The Commission Number - HURNER SPG 2.0 Manual De Instrucciones

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
"Pipe Length on" means that the length of both pipes/com-
ponents has to be entered before every welding, "off,"
that this is not possible.
"Weather Conditions on" means that the weather has to be
selected in a list before every welding, "off," that this
is not possible.
"Installing Company on" means that the company that per-
forms the installation work has to be entered before ev-
ery welding, "off," that this is not possible.
"Print Tags – M – " means that by pressing the MENU key,
the user can access a sub-menu for starting to print (a)
label(s) with reference to a given welding operation, us-
ing the optional label tag printer.
All data that are available in the chip of a transpon-
der card can be entered by placing the card in front
of the RFID reader. If they are encoded in a bar code,
Info
they can be read using a handheld scanner.
4.2

Entering Preformatted and User-defined Traceability Data

All traceability data enabled in the configuration menu at
"Recording" (see Sect. 4.1.6) have to be entered before the
welding process. The welding system prompts the user to
enter them before the welding process proper. Depending
on what data is entered, either its repeated input is man-
datory (e. g., the welder ID code; see Sect. 4.2.1) or previ-
ously entered data can be changed and confirmed or con-
firmed without changes (e. g., the commission number; see
Sect. 4.2.2).
4.2.1

Entering the Welder ID Code

When the welding is started by pressing the START/SET key
while Display 3 is showing, first the input of the welder iden-
tification code is requested, if it is enabled in the configura-
tion menu (see Display 13). The code has to be an ISO-com-
pliant code. It can be entered either using the cursor keys
(see the first info in Sect. 4.1) and confirming the input by
pressing the START/SET key, or by reading a RFID transpon-
der card or scanning it from a bar code with the optional
handheld scanner.
When the code was properly scanned or entered, this is con-
firmed by an audible signal.
4.2.2

Entering or Changing the Commission Number

From Display 3 or after the welder identification code was
entered, the machine requests the input of the job num-
ber, or commission number, of a maximum 32 characters, if
it was enabled in the configuration menu. If a commission
number exists already in memory, this one is proposed. You
can either confirm it by pressing START/SET or change it us-
Version November 2022 HÜRNER SPG 2.0 User's Manual
Enter Welder Code
++++++++++++++++++++
++++++++++
Display 13
Enter Commission No.
++++++++++++++++++++
++++++++++++
Display 14
EN
15