Entering Oder Changing Other Component Traceability Data; Performing The Butt Welding - HURNER SPG 2.0 Manual De Instrucciones

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
4.2.4

Entering oder Changing Other Component Traceability Data

In the same way as the welder identification code, commis-
sion and welding number, other data relating to the com-
ponents can be entered if they were enabled in the config-
uration menu. They are requested in the following order:
length of the 1 pipe, code of the 1
st
pipe, code of the 2
nd
ditions, additional data (as defined by the user).
If pipe codes for the two pipes are entered and if
those pipe codes state different sizes and/or Stan-
dard Dimension Ratios (SDR) for the pipes, then a
Info
code error is triggered since these welding param-
eters must be identical for both pipes.
All data can be entered by using the cursor keys (see the
first info in Sect. 4.1) and confirming by pressing the START/
SET key or can be scanned from a bar code with the option-
al handheld scanner or an RFID card using the transponder
reader. One exception is the weather (see Display 15), which
is presented as a list in which the applicable conditions can
be selected by pressing ñ or ò and confirmed, by pressing
the START/SET key.
4.3

Performing the Butt Welding

To start welding, clamp the pipes into the machine chas-
sis according to the product's User's Manual. If Tees, el-
bows, and other short pipeline components are planned to
be welded with a welding system that enables this, prepare
the system for this process as indicated in its User's Manual.
To allow not only jointing a tee, crosspiece, and
Y branch-off to a straight length of pipe, but, rath-
er, manufacturing them, likewise, to manufacture
Important
an elbow of segments jointed to each other at an
angle, the system has to have pipe segment weld-
ing enabled in the configuration menu (refer to
Sect. 4.1.2). In that case, as part of the input or con-
firmation of the component parameters, the weld-
ing system prompts the user for the kind of joint-
ing operation at hand: straight or sergmented-bend
pipe joint or production of a tee or crosspiece ("X")
or Y branch-off. Select the appropriate kind of joint
in the displayed listing using the ñ and ò cursor
keys and confirm your selection by pressing the
START/SET key. If you select a welding type other
than a straight pipe joint, the system displays anoth-
er prompt for entering details on this non-straight
jointing operation and, possibly, the step in the pro-
tocol that the jointing in hand is going to represent.
Version November 2022
pipe, length of the 2
st
pipe, code of the fitting, weather con-
HÜRNER SPG 2.0 User's Manual
nd
Weather
>sunny
clear
rain
Display 15
17
EN