arietta Argo Guía De Instrucciones Para Instalación página 7

Venting Outside Through the Wall
1. Measure from the bottom of the range hood liner to the
horizontal centerline of the vent opening (A)
B
A
C
2. Remove the vent duct from the range hood liner. Transfer
measurement A to the cabinet back wall. Measure from the
underside of the cabinet.
3. Mark the cutout as shown. Use a saber saw or keyhole saw
to cut a round opening through the top of the cabinet and the
exterior wall for the vent.
C
A
B
Non-Vented (recirculating) Installation through the
Cabinet / Soffit
Recirculating through
the cabinet top wall
A
G
B
D
F
I
E
H
A. Ceiling
B. Recirculating grid
C. Soffit
D. 6" round vent system
E. Range hood
Recirculating through the soffit
A. Measurement A
B. Horizontal centerline of vent opening
C. Range hood liner
A. Measurement A
B. Centerline
C. 6¼" (15.9 cm) round
cutout
F. Cabinet
G.Wall
H. 12" (30.5 cm) min. cabinet height
I. 17" (43.2 cm) min. vent cover height
B
G
C
F D
E
A. Ceiling
B. Recirculating grid
C. Soffit
D. 6" round vent system
1. Measure and mark the centerline of the cabinet to the soffit
above.
2. Measure from the bottom of the cabinet to the centerline of
the where the vent will come through the soffit or cabinet top
wall. Mark the location and use a saber saw or keyhole saw to
cut a 5¾" (14.6 cm) hole for the vent cover.
*NOTE: For 12" (30.5 cm) high cabinets a 6¼" deep x 8" wide
(14.6 cm x 20.3 cm) rectangular opening in the cabinet top is
required for damper transition clearance.
3. Consider the cutout chart measures to make the openings
on the cabinet. NOTE: 12" (30.5 cm) high cabinets without a
soffit may allow the 6" vent and vent cover to be seen.
4. Cover the grill that protects the suction motor with the carbon
filter so that the slots on the filter correspond to the pins on
the sides of the motor protection grill.
5. Turn the carbon filter clockwise to block them (bayonet fixing).
NOTE: The charcoal filters cannot be cleaned. It should be
replaced every 4-6 months (depending on hood usage).
You must cut the cable tie attached to the blower to make a
proper installation.
7
A
E. Range hood
F. Cabinet
G.Wall
A
B
A. Vent cover
B. Centerline