Pit Boss COMPETITION Serie Montaje Y Operación página 12

The COOK readout displays the desired temperature that you want to achieve in the Main Barrel. To
adjust the COOK temperature, push the Controller Knob to activate, rotate the Controller Knob to
change the temperature, then push the Controller Knob to confirm the chosen value.
Displays the temperature of the connected Meat Probe(s). The displayed Meat Probe readout will
correspond with the plug-in connection port(s) selected on the front of the Control Board. When not in
use, disconnect the Meat Probe from the connection port and code "noP" will be displayed. Compatible
with Pit Boss® branded Meat Probes only. Additional Meat Probe(s) sold separately.
This button has two functions: "P" Set and Temperature Units Switch.
1. The "P" Set Button is used to select one of the eight fine tunings when the Controller Knob is
set to the S (Smoke) Setting. Press the button to change the "P" setting value to accommodate
to your cooking style and cooking environment, as preferred. With a short push of the button,
the setting increases from P0 to P7, then repeats. Adjustments are only possible in the S (Smoke)
Setting. Factory default setting is "P4". If the "P" setting is adjusted, your preference will be locked-
in (saved) until further adjustment is made.
2. Press and hold this button for two seconds to activate the Temperature Units Switch, changing the
temperature readout. Change between Celsius (ºC) and Fahrenheit (ºF), as preferred. Default is set
to Fahrenheit.
Press and hold this button to activate a manual, continuous feeding of pellets to the Burn Pot. Releasing
the button will stop the manual feeding of pellets. This can be used to add more fuel to the fire before
opening the barrel lid, resulting in a quick heat recovery. It can also be used while smoking, to increase
the intensity of clean smoke flavor. This feature was requested from competition cookers.
The FAN icon is visible when the fan is in operation. When the central readout has an error code (Err)
and the FAN icon is blinking, the Fan is not working. See the section on troubleshooting for assistance.
The AUGER icon is visible when the auger is turning. When the central readout has an error code (Err) and
the AUGER icon is blinking, the auger is not working. See the section on troubleshooting for assistance.
The Igniter icon is visible when the igniter is in use. When the central readout has an error code (Err) and
the Igniter icon is blinking, the igniter is not working. See the section on troubleshooting for assistance.
When the central readout has an error code (Err) and the PELLET icon is visible, the fire in the Burn Pot
has gone out or the hopper may be empty. See the section on troubleshooting for assistance.
12