Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
starlight pro
4.2
Connecting the Accessories
In order to make the equipment operational it is necessary to proceed as follows:
1.
Place the charging unit on a flat surface;
2.
Plug the power cable (Figure 4 at page 8 - Ref. F) into the connector on the back side
of the charging unit (Figure 5 at page 10 - Ref. A) and then into the power outlet. The
green power LED should light up (Table 1 at page 11 - Ref. A).
CAUTION: Make sure that the voltage and frequency of the power-supply line match the
values indicated on the identification label under the charging unit.
! WARNING: Check the condition of the power cable regularly. If it is found to be damaged,
replace it with an original Mectron spare part.
CAUTION: Place the device in such a way as to always have the power plug easily
accessible as it is considered to be a disconnection device.
10
A
Figure 5 – Charging unit.
B
Publicidad
Tabla de contenido
