Sauder Hammond 423527 Manual De Instrucciones página 28

Step 23
å
Separate the WIDE EXTENSION SLIDES (32) from the WIDE EXTENSION RAILS (31) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten the WIDE EXTENSION RAILS (31) to the KEYBOARD UPRIGHTS (R and S). Use six BLACK 5/8" FLAT HEAD
SCREWS (26).
å
NOTE: For each WIDE EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the
inner cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the UPRIGHTS. Turn a
SCREW into these holes.
å
NOTE: The WIDE EXTENSION SLIDES will be used later for the KEYBOARD SHELF.
å
Insert four LARGE WOOD DOWELS (6) into the long edges of the KEYBOARD UPRIGHTS (R and S).
32
Push the release lever in and pull the SLIDE from the RAIL.
6
Page 28
BLACK 5/8" FLAT HEAD SCREW
31
R
www.sauder.com
31
26
(8 used in this step)
31
S
Open end
Finished edge
6
Open end
423527