Sauder Hammond 423527 Manual De Instrucciones página 9

Step 4
å
Separate six EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the LEFT END (C) and LEFT UPRIGHT (D). Use eighteen BLACK 5/8" FLAT HEAD
SCREWS (26).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that line up with the holes in the END and UPRIGHT. Turn a
SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
2
Push the release lever in and pull the SLIDE from the RAIL.
1
423527
BLACK 5/8" FLAT HEAD SCREW
1
1
C
Open end
www.sauder.com
26
(18 used in this step)
1
Open end
The CAM
SCREW
should be
here.
1
1
1
D
The CAM
SCREW
should be
here.
Open end
Open end
Page 9