Drawer Back - Sauder Hammond 423527 Manual De Instrucciones

Step 30 Step
1
BLACK 1/2" FLAT HEAD SCREW
(6 used in this step)
2
FF
å
Fasten the EXTENSION SLIDES (2) to the LARGE
DRAWER SIDES (FF and GG). Use six BLACK 1/2"
FLAT HEAD SCREWS (28). Use the exact holes shown
in the upper view.
3
GG
HH
å
Slide the DRAWER BOTTOM (W) into the grooves in the
LARGE DRAWER SIDES (FF and GG) and SMALL
DRAWER BACK (HH).
423527
2
28
Open end
2
GG
These
holes
must be
here.
With the palm of
your hand, tap
the DRAWER
BOTTOM down
into the grooves.
W
FF
www.sauder.com
2
BLACK 1-3/8" FLAT HEAD SCREW
(4 used in this step)
FF
å
Fasten the LARGE DRAWER SIDES (FF and GG) to
the LARGE DRAWER BACK (HH). Use four BLACK 1-3/8"
FLAT HEAD SCREWS (23).
4
FF
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
FRONT groove.
å
Fasten the LARGE DRAWER FRONT (EE) to the LARGE
DRAWER SIDES (FF and GG). Tighten four HIDDEN CAMS.
å
Fasten a KNOB SET (10) to the LARGE DRAWER
FRONT (EE). Use a BLACK 1/2" MACHINE SCREW (30).
23
GG
HH
Groove
BLACK 1/2" MACHINE SCREW
(1 used in this step)
GG
EE
10
Page 35
30