Important - Dogtra Europe YS300 Manual De Instrucciones

Indicator Light
(LED Window)
Indicator Light (LED window)
The indicator light (LED Window) will flash 1 second
when the Dogtra YS300 has been turned on. Then after 2
seconds, it will flash every 2 seconds. If the dog does not
bark for over 10 seconds, it will turn to the Sleep mode to
save battery life and the LED will turn off.
Before going into Sleep mode, the LED light flashes
green when the battery is fully charged and turns to
amber when the battery life is getting low. When the LED
indicator emits a blinking red light, the battery needs to
be recharged.
Battery
Fully charged
LED
window
On Working
Flashes Green
On Charging Stays on Green
32
Medium charge Needs charge
Flashes Amber Flashes Red
Stays on Red Stays on Red
Contact Points
YS300 uses Surgical Stainless Steel contact points to
protect the dog's skin. The length of the contact points
should be wellfitted so that the contact points are held
firmly against the dog's skin.
IMPORTANT : Avoid touching the Contact points unless
the Anti-Bark Collar is completely discharged, or you may
feel the electrical stimulation yourself.
Plastic Dummy Contact Points
If your dog is trained enough, you can replace the
Contact Points with the Plastic Contact Points included
in the package. By doing so, it will allow you to keep
the collar on your dog for a longer period of time with
less irritation on the skin. You may also use the Pager
mode as a useful tool in correcting your dog without the
stimulation, however, only leave the collar on for 8-hour
at a time if the stainless steel contact points are still being
utilized.
33