Testing Your Anti-Bark Collar - Dogtra Europe YS300 Manual De Instrucciones

Collar Strap Adjust
The collar strap of the YS300 can be adjusted 3 steps as
shown in the diagram above.
To adjust the collar strap, first unscrew the contact points
and put screws in desired holes, then tighten the contact
points as shown below.
34

TESTING YOUR ANTI-BARK COLLAR

1. Turn the YS300 on by turning the ON-OFF & Intensity
Dial and select "TEST" Level so that the arrow on the dial
is aligned with the "test" line. The LED indicator light will
flash 1 second to indicate that it is on, after 2 seconds it
will flash every 2 seconds. If the dog does not bark over 10
seconds, it will turn to the Sleep mode to save battery life
and the LED will turn off.
2. Test by scratching the rough surface of the test tool on the
collar (as shown in the diagram) using a coin. The collar
will emit a vibration three times. Then repeat the same
process if you want to try it again.
* When the Anti-Bark Collar emits a vibration, a
stimulation is not emitted at the same time.
* When you set the dial on the TEST Level, it may be
sensitive enough that the Anti-Bark Collar can be
activated easily by a small sound.
35