Collar Fitting - Dogtra Europe YS300 Manual De Instrucciones

The GS mark, which is regulated by German
law and recognized worldwide, is a seal of
approval for "Geprüfte Sicherheit" (Tested
Safety) and means that the product is in
compliance with the German product Safety
Law.
The Conformité Européenne (CE) Mark is the
European Union's (EU) mandatory conformity
marking for regulating the goods sold within
the European Economic Area (EEA).
A Class II or double insulated electrical
appliance is one which has been designed in
such a way that it does not require a safety
connection to electrical earth (ground).
For indoor use only
Do not dispose of your product with your
household waste. It has to be disposed
of in compliance with your local WEEE
(Waste Electrical and Electronic Equipment)
Regulations.
A power supply with this marking is in
compliance with the global energy efficiency
regulations, including the upcoming US
Department of Energy's (DoE) Level VI
efficiency standard.
38

COLLAR FITTING

The collar should be fitted so that the contact points
press firmly against the dog's skin. When properly
fitted, you should be able to fit a finger or two snugly in
between the contact points and your dog's skin. When
properly fitted, the receiver should not move on the
dog. The best location for the receiver is either side of
the dog's windpipe. A loose fit can allow the receiver to
move around on the dog's neck and cause irritation. If the
collar is too tight, the dog may have difficulty breathing.
Leaving the receiver in the same location on the dog's
neck for an extended period of time can cause skin
irritation. If the dog is to wear the collr for long periods,
occasionally reposition it every few hours so that the
contact points are moved to a different location on the
dog's neck and remove it after 8 hours of usage. Check
for skin irritation each time you use the unit.
39