Publicidad
Idiomas disponibles
Idiomas disponibles
B
Using the appliance
Installing the oven
• Electrical installation of this appliance must be performed only by a licensed electrician. The
oven must be installed according to the instructions supplied. Remove the protective vinyl from
the door after installation.
Safety instructions for the installer
• Installation must guarantee protection against exposure to electrically live parts.
Installation of built-in ovens
• In order to ensure that the built-in appliance functions properly, the cabinet containing it must
be appropriate.The figure below gives the dimensions of the cut-out for installation under the
counter or in a wall cabinet unit.
NOTE:
Installation in compliance with the consumption declaration
• In order to ensure adequate ventilation, the back panel of the cabinet unit must be removed.
Installing the oven so that it rests on two strips of wood is preferable. If the oven rests on a
continuous, flat surface, there must be an aperture of at least 45 × 560mm.
6
EN
B
Using the appliance
• The panels of the adjacent cabinets must be made of heat-resistant material. In particular,
cabinets with a veneer exterior must be assembled with glues which can withstand temperatures
of up to 100°C.
• In compliance with current safety standards, contact with the electrical parts of the oven must
not be possible once it has been installed.
• All parts, which ensure the safe operation of the appliance, must be removable only with the
aid of a tool.
• To fasten the oven to the cabinet, open the door of the oven and attach it by inserting the
4 wooden screws into the 4 holes located on the perimeter of the frame.
Electrical Connection
Those ovens equipped with a three-pole power supply cable are designed to operate with an
alternating current. The wire for earthling the appliance is yellow-green in color.
Fitting on a Power Supply Cable
45 mm
560 mm
7
EN
Publicidad
