Publicidad
Idiomas disponibles
Idiomas disponibles
d. The temperature set-point is included between 17°C and 30°C (from 62 F and 86 F) with 1°C variations
and it can be set using the keys +/- on the control panel or with the keys ▲ ▼ on the remote control.
e. After a certain time (maximum three minutes) after the activation of the operation mode, the heat pump
activates and the appliance starts delivering warm air.
f. Connect the condensation discharge pipe (paragraph 2.6.b)
3.11 TIMER MODE
a. This mode allows to program the switching on or the switching off of the appliance.
b. The delay time can be set, activated and cancelled both from the remote control and from the control
panel.
3.11.a Programmed switching on
a. When the appliance is in standby mode, select the operation mode, the desired temperature and ventilation
speed.
-
On the control panel:
-
On the remote control: - press the key "TIMER ON" to access the function and then press the key
b. Once the set time has passed, the appliance starts with the same settings (mode, temperature and ven-
tilation speed) as those before switching off.
c. Time can be set with 30 minutes steps up to 10 hours and with 60 minutes steps from 10 to 24 hours.
d. Starting the appliance or adjusting the timer setting to "0.0h" will cancel the programmed switching on
function.
3.11.b Programmed switching off
a. When the appliance is running, set the delayed switching off time.
-
On the control panel:
EN - 20
- press
and set the switching on delay time with the keys +/-.
- To activate the function, press
the set time on the display stops flashing (the display returns to showing
the environment temperature).
The icon
lights up.
"TIMER ON" once or more until the switching on delay time is set.
- Direct the remote control towards the appliance; a beep confirms the acti-
vation of the function.
- The icon
on the control panel and the indicator "Timer On" on the remote
control display light up.
- press
and set the switching off delay time with the keys +/-.
- To activate the function, press
the set time on the display stops flashing (the display returns to showing
the environment temperature).
The icon
lights up.
or wait approximately 5 seconds so that
or wait approximately 5 seconds so that
Publicidad
