Lavorwash EVO 850 Manual De Instrucciones página 42

To stop the detergent dispensing system, turn the switch, ITEM C FIG. 2, anti-clockwise to the "OFF" position.
In this case the machine only supplies water .
The detergent tank, ITEM 1 FIG . 6, is located behind the access door, ITEM 2 FIG . 6, in front of the machine .
The 3-litre tank can be replaced without the need for decanting as it is disposable commercial packaging .
It is possible to visually check the level of the detergent in the tank through the inspection opening, ITEM 1 FIG .
7
FIG. 6
BEFORE PROCEEDING, MOVE THE KEY SWITCH (ITEM H FIG. 2) INTO THE OFF
POSITION AND REMOVE THE KEY.
Operation only necessary if the squeegee unit has been disassembled for transportation
requirements.
Slide the floor squeegee unit, ITEM 30 FIG. 4, onto the relative fixing bracket, ITEM 3 FIG. 8, and tighten the
flap knobs, ITEM 2 FIG. 8, of the floor squeegee.
Connect the recovery hose, ITEM 3 FIG. 8, at the inlet of the floor squeegee, ITEM 5 FIG. 8.
FIG. 8
2
DETERGENT TANK
1
2
INSTALLING THE SQUEEGEE UNIT
4
FIG. 7
1
5
3
42
2
3