cecotec bongo A Serie Manual De Instrucciones página 44

ENGLISH
electric scooter can be linked to your Smartphone and you can check information and settings.
How to ride the electric scooter
Press the power push button for 2 seconds.
Fig. 29.
Stand on the board with 1 foot and kick off with the other one to start the scooter.
Fig. 30.
Place both feet on the footrest.
Fig. 31.
Press the throttle push button with your right hand and rotate the handle towards your body.
Fig. 32.
Press the throttle push button to speed up.
Warning: Do not ride too fast.
Fig. 33.
Press the brake to stop or decrease speed.
Press the rear fender with the foot to assist the braking process.
Fig. 34.
Only get off the scooter when riding at very low speed or when it is stopped.
Fig. 35.
How to charge the electric scooter
Open the charge port cover. Make sure it is clean and dry.
Connect the charger with the battery and the other end to the power supply. Check the battery
indicator is on.
The light indicator will change colour when it is fully charged.
Fig. 36.
Note: Once the light indicator changes colour, stop charging it. If the battery is left to overcharge
for a long time the battery service life can be affected.
Warning: Cover the charge port with the anti-dust tab to avoid dust from entering.
Charging method 1
Fig. 37.
Charging method 2
Fig. 38.
Battery interface
Charge port
Use of the tyres
For a correct operation of the scooter, always check and maintain the correct pressure of your
44
BONGO SERIE A CONNECTED