cecotec bongo A Serie Manual De Instrucciones página 45

ENGLISH
tubeless tires.
The optimum tyre pressure is 50 PSI / 3.4 bar / 340 kPa.
If you are using the scooter for the first time, make sure the pressure is correct. We recommend
checking the pressure regularly to ensure that the pressure is on the recommended values for
efficient driving.
We recommend the use of a heat-sealed gel on the tyres to prevent punctures and maintaining
its effectiveness and features.
5. CLEANING AND MAINTENANCE
Make sure the robot is disconnected from the power plug and switched off before cleaning or
repairing it.
Use a soft cloth to clean the outside part of the scooter.
Do not immerse the scooter in water or other liquids to clean it. This could cause permanent
damage to its electronic parts.
Do not try to repair the appliance by yourself. If it presents any damage or fault, contact the
Technical Support Service of Cecotec.
Storage
Make sure the scooter is charged before being stored for long periods of time. Charge it at least
once a month.
Only charge it at a room temperature between 0 ºC and 35 ºC and store it between - 10 ºC and
35 ºC.
Store the scooter indoors, in a dry and safe place. Cover it or wrap it to protect it from dust if
necessary.
6. TROUBLESHOOTING
Fig. 39
In case of overheating, stop the product and wait until the engine cools down.
Fig. 40
Defective engine: C
Defective accelerator: B
Defective brake: A
Warning: These parts must be repair if any of the signs show in the screen. Please contact with
our Technical Support Service.
45
BONGO SERIE A CONNECTED