Publicidad
Idiomas disponibles
Idiomas disponibles
Correct support – Observe the maximum work
piece dimensions. Always use and secure ex
tensions to the workpiece support. Otherwise,
the workpiece may be subjected to internal
stresses, which may lead to sudden deforma
tions. Observe the information for workpiece di
mensions (see section 10.4).
10A
10-4
10B
Proceed as follows to clamp the workpiece
► Push the saw unit downwards until it reach
es the limit stop.
► Pull the lever for the transport locking de
vice [10-1].
► Slowly guide the saw unit upwards.
► Place the workpiece so that it is flush with
the stop ruler [10-3].
► Use the fastening clamp [10-2] to secure
the workpiece in place.
► Check that the workpiece is securely in
place.
10.4 Observe the workpiece dimensions
Maximum workpiece dimensions without
extension using accessory parts
Mitre/bevel
angle, to
scale
0°/0°
10-1
45°/0°
0°/45° right
10-2
10-3
0°/45° left
45°/45° right
45°/45° left
Maximum workpiece dimensions when
installing together with UG-KS60 and KA-KS60
The maximum height and width of the work
piece do not change if accessory parts are in
stalled. The contact surface when installing the
underframe must be the same as the contact
surface when the extension table is extended.
Accessory part used
UG-AD-KS60
KA-KS60 (one side)
KA-KS60 (both sides)
Long workpieces
Provide extra support for any workpieces that
protrude over the sawing surface:
► Provide extra support for any workpieces
that protrude over the sawing surface:
► Adjust the extension table, see section 9.5.
► If the workpiece still protrudes, retract the
extension table and install a KA-KS60 trim
ming attachment, or raise the compound
mitre saw using A-SYS-KS60 screw-in feet
Height x width x length
2-6/16" x 12-1/64" x 28-11/32"
(60 x 305 x 720 mm)
2-6/16" x 8-1/2" x 28-11/32"
(60 x 215 x 720 mm)
3/4" x 12-1/64" x 28-11/32"
(20 x 305 x 720 mm)
1-9/16" x 12-1/64" x 28-11/32"
(40 x 305 x 720 mm)
3/4" x 8-1/2" x 28-11/32"
(20 x 215 x 720 mm)
1-9/16" x 8-1/2" x 28-11/32"
(40 x 215 x 720 mm)
Length
28-11/32"
(720 mm)
(74-1/16"–110-15/64"
(1880–2800 mm)
132-9/32"–204-23/32"
(3360–5200 mm)
English
21
Publicidad
