Publicidad
Idiomas disponibles
Idiomas disponibles
English
14
14-3
14-2
14-1
14-1
11.3 Cleaning/replacing the spotlight
window
The spot lighting SL‑KSC60 lights up the cutting
edge on the workpiece. Dust-intensive work
may affect the power of the light. Proceed as
follows to clean the spotlight [15]:
► Move the machine into the working position.
► Pull out the spotlight window [15-1] by
hand, and clean/replace it.
► Reinsert the spotlight window.
The spotlight window audibly clicks into
place.
15
15-1
12 Transportation
CAUTION
Risk of crushing
The saw unit may swing out/extend
► The machine must always be transported
in the transport position that has been pro
vided for this purpose.
26
CAUTION
Risk of injury!
The power tool may slip out of your hands
when you are carrying it.
► Always carry the power tool with both
hands, using the carrying handles [16] pro
vided on both sides of the power tool.
12.1 Securing the machine (transport
position)
► Remove the battery pack from the power
tool.
► Move the saw unit into the rear position and
lock it in place using the rotary knob [1-6].
► Swivel the saw unit into a vertical position.
▷ Loosen the star handle [2-6].
▷ Move the saw unit into a vertical posi
tion.
▷ Tighten the star handle.
► Lock the saw unit in place.
▷ Press and hold the safety button [1-3].
▷ Move the saw unit downwards until it
reaches the limit stop.
▷ Pull the lever for the transport locking
device [1-7].
▷ Release the safety button.
The saw unit remains in the lower position.
► Swivel the rotary base into the right-hand
position.
▷ Release the rotary knob [1-14].
▷ Press and hold the detent lever [1-13].
▷ Swivel the rotary base [1-15] as far to
the right as it will go.
▷ Release the detent lever, close the rota
ry knob.
The machine is in the transport position [16].
12.2 Carrying handles provided
–
Handle on the saw unit [16-1]
–
Handle on the key storage box [16-3]
–
Extension tables [16-2] (when fixed in
place)
Publicidad
