Dalla Corte Dc pro Manual De Usuario página 36

setting up for installation
Place the machine on a surface that
guarantees a secure support.
To get ready for set up, make sure you
have an opening of at least 10x10 cm
on the support surface (A-pic.1) to allow
connection with systems in the space
below (B-pic.1).
The machine should be connected to
an appropriate drinking water source
compliant with national laws.
The incoming water pressure should
be between 0.1 and 0.6 MPa. If such
requirement is not met, please consult
the manufacturer.
A tap must be installed between water
system and machine water hose in
order to be able to stop water flow if
necessary (1 pic.1).
All manuals and user guides at all-guides.com
Connect a 40 mm diameter drain siphon
(5 pic.1) with the local drain system
(4 pic.1).
The machine is not equipped with
any plug since it is designed to be
connected directly to the electrical
system – an omnipolar switch compliant
with national laws must therefore be
installed (7 pic.1).
-> pic. 1