Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Water coming out of
steam wand
Hot water isn't
continuously flowing
Lever very hard
to tamp
Puck surface is not
flat and smooth
Puck surface has some
loose grounds on top
Tamp height is not
at desired level
Tamp light continues
to flash and no height
reading on gauge after
tamping
When maintenance
light indicator
flashes
When maintenance
light indicator
illuminates solid
* Razor – See page 10 for accessories list.
POSSIBLE CAUSES
•
Machine is heating up.
•
Machine is too hot after
steaming.
•
Severe overdose.
•
Coffee build-up in mechanism.
•
Coffee grinds stuck on tamp face. Remove shroud (tamp) cover and clean using
•
Coffee grinds caught on tamp.
•
Coffee grinds caught on tamp
from tamping too quickly.
•
Machine is on auto mode, that is
for ideal height only.
•
Tamping action is not
completed.
•
Cleaning cycle is required.
•
Descale cycle is required.
WHAT TO DO
Purge steam wand before texturing milk.
Refer to pages 20-21 'Texturing Milk'.
Allow machine to cool down.
Use the Razor trimming tool* to correct
current dose. Select the correct filter size.
Remove shroud (tamp) cover and clean using
the cleaning brush provided.
the cleaning brush provided.
Push the tamp lever again for a very polished
coffee puck.
Push the lever down slower.
Use Manual Mode for custom control.
Push the tamp lever down until you hear
the beep.
The maintenance light indicator
when a cleaning cycle is required.
Go to
Care & Cleaning section for
cleaning and descaling instructions.
The maintenance light indicator
solid light when a descale cycle is required.
Go to
Care & Cleaning section for
cleaning and descaling instructions.
EN
will flash
is on
31
Publicidad
