Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE AND REPAIR
If there appears to be a malfunction during the operation of the meter, the
following steps should be performed in order to isolate the cause of the
problem.
1. Check the battery. Replace the battery immediately when the symbol
"
" appears on the LCD.
2. Review the operating instructions for possible mistakes in operating
procedure.
Except for the replacement of the battery, repair of the meter should be
performed only by a Factory Authorized Service Center or by other qualified
instrument service personnel. The front panel and case can be cleaned with
a mild solution of detergent and water. Apply sparingly with a soft cloth and
allow to dry completely before using. Do not use aromatic hydrocarbons,
Gasoline or chlorinated solvents for cleaning.
Make sure the electrode is clean! Between measurements,rinse the electrode
with deionised water. If the electrode has been exposed to a solvent immiscible
with water, clean it with a solvent miscible with water e.g. ethanol or acetone
and rinse carefully with water.Store the electrode carefully! Before storing, rinse
it carefully in deionized water and store DRY.
Battery Replacement
1. Turn off the meter and open the battery cover.
2. Replace the old batteries with four new AAA batteries.
11
Publicidad
