Eurocave Compact 59 Serie Modo De Empleo página 13

1/ DESCRIPTION OF YOUR WINE CABINET
R
A
B
C
D
E
F
G
H
I
J
K
A
Control and adjustment panel
B
Light (2 leds)
C
Air circulation hole + Active carbon filter
D
Sliding shelf
E
Closing clip
F
Storage shelf
G
Grid
H
Humidity cassette (1 temperature models)
I
Power lead
J
Base with front ventilation
K
Aeration filter access grille
6
GB
Q
P
O
N
M
L
L
4 adjustable levelling feet
M
Lower hinge (x2)
N
Specification label
O
Free air circulation hole
P
Door (fitted with handle and a double movement
lock)
Q
Upper hinge
R
Rear stop (S-259V3 - V-259V3)
2/ POWER SUPPLY
The wine cabinet power lead has a plug to be plugged into a standard earthed socket to prevent
any risk of electric shock.
Contact your usual EuroCave dealer to change the power lead if it is damaged. It must be replaced
by a part which has an original manufacturer's guarantee.
3/ PROTECTING THE ENVIRONMENT
ECODESIGN
Spare parts for our appliances are available for 11 years. For further
information, contact your EuroCave stockist. For France, contact our
customer service department. Contact details at www.eurocave.com
Disposing of packaging
The packaging used by EuroCave is produced in recyclable
materials.
After unpacking your cabinet, take the packaging to
a refuse collection point. For the most part, it will be
recycled.
Recycling: a caring gesture
Electronic and electrical equipment has potentially harmful effects on
the environment and human health, owing to the presence of dangerous
substances.
Therefore, you must not trash electrical and electronic equipment with
non-sorted municipal waste.
4/ INSTALLING YOUR WINE CABINET
Unpacking
•
When your cabinet is delivered, check the outside for signs of damage
(impact, warping...).
•
Open the door and check that the various elements inside are intact
(walls, Main du Sommelier supports, hinges, bottle support...).
•
Protective wedges for transportation have been attached to each shelf. 2
wedges per shelf (Picture 1). Remove all of them using a rotating movement
(Picture 2). You can retain these wedges and reuse them if you have to
transport your wine cabinet over a long distance.
Have the mains socket inspected by a qualified electrician who will check that it is
correctly earthed and will carry out, if need be, work to bring your installation into line
with standards.
If you are moving to a foreign country, check whether or not the cabinet's characteristics
correspond to the country (voltage, frequency).
When purchasing a new EuroCave product, you can entrust the recycling
of your old appliance to your EuroCave dealer.
Speak to your EuroCave dealer, he will advise you on the disposal and
collection arrangements set up within the EuroCave network.
In compliance with legislation on protecting and caring for the environment,
your wine cabinet does not contain C.F.C.s.
Energy-saving
Install your cabinet in a suitable location (see following page) and observe
the recommended temperature ranges.
•
Keep the door open only for very short periods.
•
Ensure that the door seal is intact and that it is not damaged. If it is,
contact your EuroCave dealer.
•
We recommend that you fill your wine cabinet to at least 75% of its
total capacity.
Disable unusable appliances by unplugging them and removing the power
lead.
Picture 1
Installation
Transport your cabinet to the chosen location.
It must:
•
away from any heat source
•
be open on the outside to allow air to circulate (not a closed
cupboard...)
•
not be too damp. Max 85% ambient humidity (linen cupboard, laundry
room, bathroom...).
•
have a stable, flat floor,
•
have a power supply (standard socket, 16 A, earthed with circuit
breaker, 30 mA* (*not applicable to some countries).
Picture 2
7
GB