Publicidad
Idiomas disponibles
Idiomas disponibles
Britax Child Safety, Inc.
Care and Maintenance
IMPORTANT:
Before each use, check this child seat and its components to make sure they are in
good condition and good working order.
Removing Booster Covers
Booster Base Cover
1. Detach the two elastic loops from under the front of the seat
base and lift the cover up.
2. Remove the SecureGuard clip by rotating the adjuster 90
degrees and sliding the adjuster through the slot (see page
14).
3. Detach the two elastic loops from the back of the seat base.
4. Remove the booster base cover.
Booster Backrest Cover
1. Raise headrest (see page 13).
2. Detach the two elastic loops from the top of the backrest.
3. Detach the four elastic loops from the bottom of the backrest.
4.
Remove the backrest cover.
NOTE: Be careful not to damage the foam.
32
Table of Contents
Booster Head Restraint Cover
1. Detach the two elastic loops from the back of the headrest.
2. Lift the head restraint cover off of the headrest.
NOTE: Remove plastic insert from head restraint cover before
washing. Reinstall before use.
Replacing Booster Covers
To replace covers, reverse the removal instructions.
Cleaning Booster Covers
• Refer to product care label for wash instructions
• If care label indicates machine washable, always refer to us.britax.com/faqs for important care
information.
• DO NOT bleach or iron.
Cleaning the Shell
• SPONGE CLEAN, using warm water and mild soap.
• TOWEL DRY
• DO NOT use solvents, abrasive cleaners, or disassemble the booster seat in any way except
as instructed.
• CUPHOLDERS: Dishwasher safe, top shelf only.
Table of Contents
HIGHPOINT User Guide
33
Publicidad
