Publicidad
Idiomas disponibles
Idiomas disponibles
Britax Child Safety, Inc.
Cup Holders
Installing the Cup Holders (Optional)
IMPORTANT:
DO NOT use cup holders with hot liquids.
1. Slide the cup holder into the booster base and press down until
a click is heard.
NOTE: The cup holders are labeled inside "L" and "R", from
the position of the child occupant, and can only be installed
as indicated.
Removing the Cup Holders
1. From under the booster base, locate the tab on the bottom of
the cup holder.
2. Pull forward on the tab to disengage the cup holder, then pull
up to remove it from the booster base.
NOTE: Cup holders are dishwasher safe.
NOTE: Cup holders can be removed to allow for side by side
seating positions.
16
Table of Contents
Lower Anchor System
The lower anchor system helps to
anchor the booster seat into the car
for added stability and safety in the
event of a crash. The lower anchor
system does not restrain your child.
You must use the lap-shoulder belt to
properly secure your child.
The figure at right shows typical
locations for lower anchors in a
vehicle. Check your vehicle owner's
manual to learn if it is equipped
with lower anchors, information
on the lower anchor locations, and
designated seating positions available
for use with this child seat.
HIGHPOINT User Guide
Vehicle Seat
Head Restraint
Vehicle Seat
Top Tether
Anchors
Vehicle Seat
Belt Retractor
Lap-Shoulder
Vehicle Seat Belt
LATCH
Seat Belt Buckles
Lower Anchors
Table of Contents
Frontal Air Bag
17
Publicidad
