Publicidad
Idiomas disponibles
Idiomas disponibles
Britax Child Safety, Inc.
Vehicle Head Restraints
WITH BACKREST: Proper positioning of the booster seat may
require adjusting or removing the vehicle head restraint to allow the
backrest to lie flat against the vehicle seat back. If the vehicle head
restraint cannot be adjusted or removed, a different seating position
or different booster seat should be used.
WITHOUT BACKREST: Use only as a backless booster when used
in a seating position with a vehicle head restraint. See your vehicle
owner's manual for booster seat positioning instructions.
In some cases, the vehicle head restraint can prevent the child seat
head restraint from being raised high enough to properly adjust the
harness for the fit of your child. DO NOT force the child seat head
restraint past the vehicle head restraint. Doing so could cause the child
seat not to perform as intended. If the location of the vehicle head
restraint interferes with the child seat head restraint, raise or remove the
vehicle head restraint. If the vehicle head restraint cannot be removed,
move the child seat to the upright position or try a different seating
location.
30
Table of Contents
The following types of vehicle seat belts are NOT compatible with this child seat. If
any of the belt types listed below are in the chosen seating position, choose another
vehicle seating position or check your vehicle owner's manual for information on
installing a car seat in your vehicle.
Lap-shoulder belts
with top or bottom
anchor points on the
vehicle door.
NOTE: This booster seat may not be compatible with every inflatable lap-shoulder belt
found in all vehicle makes and models. See FAQs in the support section of the Britax
website (us�britax�com/faqs) for additional instructions.
HIGHPOINT User Guide
Motorized, automatic
Lap only belts
vehicle seat belts.
Table of Contents
31
Publicidad
