Publicidad
Idiomas disponibles
Idiomas disponibles
Britax Child Safety, Inc.
SecureGuard Clip
Britax recommends using the SecureGuard clip to achieve best vehicle
seat belt placement. The SecureGuard clip should hold the lap part of the
vehicle seat belt in place.
The SecureGuard clip should be adjusted to keep the lap part of the vehicle
seat belt positioned low across your child's upper thighs. Ensure the
bottom edge of the SecureGuard clip is level with your child's upper thighs;
however, the clip itself should not press into your child's upper thighs.
IMPORTANT:
The lap part of the vehicle seat belt must not rest on the
child's abdomen.
Adjusting the SecureGuard Clip
1. Remove the SecureGuard Clip.
a. Lift up the front of the base cover by removing the elastics
at the front of the base (see page 32).
b. Locate the SecureGuard retainer clip and rotate the Secure
Guard strap 90 degrees.
c. Slide the SecureGuard retainer clip through the slot and pull
through the opening and away from the base.
14
Table of Contents
2. Adjust the SecureGuard webbing.
•
To Shorten: Feed the webbing through the SecureGuard
retainer clip and pull the end of the SecureGuard webbing
to tighten.
•
To Lengthen: Feed the end of the SecureGuard webbing
through the retainer clip and pull the webbing to remove
slack from the SecureGuard retainer clip. Then, move the
SecureGuard clip to the center of the SecureGuard webbing.
NOTE: The lower edge of the SecureGuard clip should be
level with the child's upper thighs once the child has been
secured in the booster seat.
3. Reattach the SecureGuard clip back into the base of the seat by
rotating the retainer clip 90 degrees and inserting it into the slot.
Ensure the SecureGuard strap is not twisted.
Table of Contents
HIGHPOINT User Guide
15
Publicidad
