2 Perform one of the following actions based on the type of emergency call:
If...
Emergency Call
Emergency Call with Hot Mic
3 To exit Emergency Call, see
12.5
Sending Emergency Alarms with Emergency Calls
Procedure:
1 Press the programmed Emergency button.
Your radio shows the following indications:
•
The radio displays the confirmation message of a successful or unsuccessful
acknowledgment from the dispatcher.
•
The radio exits Emergency Alarm and enters the Emergency Call state.
2 Perform one of the following actions based on the type of emergency call:
If...
Emergency Call
Emergency Call with Hot Mic
3 To exit Emergency Call, see
Then...
a Press and hold the PTT button.
b Speak into the microphone.
c To end the transmission and wait for a
response from the dispatcher, release
the PTT button.
Speak into the microphone.
Exiting Emergency Operation on page
Then...
a Press and hold the PTT button.
b Speak into the microphone.
c To end the transmission and wait for a
response from the dispatcher, release
the PTT button.
Speak into the microphone.
Exiting Emergency Operation on page
MN005642A01-AR
Chapter 12 : Emergency Operation
NOTE:
The Hot Mic applies to the first
voice transmission from your ra-
dio during the Emergency call. For
subsequent transmissions in the
same Emergency call, you must
press the PTT button.
62.
NOTE:
The Hot Mic applies to the first
voice transmission from your ra-
dio during the Emergency call. For
subsequent transmissions in the
same Emergency call, you must
press the PTT button.
62.
61