Nilfisk Liberty SC60 Instrucciones De Uso página 19

DETERGENT SYSTEM PURGE
To Purge When Changing Detergent (SCRUB AND SOLUTION SYSTEMS MUST BE OFF):
SERVICE NOTE: Move machine over floor drain before purging because a small amount of detergent will be dispensed in the process.
1 Disconnect and remove the detergent cartridge.
2 Turn the Key Switch (27) to ON (I) to power on the machine. Wait a few seconds for the start-up sequence to finish.
Press and hold the Detergent Mode Increase Switch (C+) and the Solution Flow Increase Switch (B+) down for 2 seconds. NOTE: Once
3
activated the purge process takes 20 seconds. Press (C+) and (B+) again before 20 seconds to cancel purge. Normally one purge cycle is
adequate to purge the system.
To Purge Weekly (SCRUB AND SOLUTION SYSTEMS MUST BE OFF):
1 Disconnect and remove the detergent cartridge. Install and connect a Cartridge filled with clean warm water.
2 Follow steps 2 and 3 from "To Purge When Changing Detergent".
When the detergent level is nearing the bottom of the cartridge it is time to refill or replace the cartridge.
SERVICE NOTE: Follow the "To Purge Weekly" instructions above if the machine is going to be stored for an extended period of time.
FIGURE 2-9
Purge
Press and hold (C+) & (B+) for 2 seconds to purge.
11/2020
INSTRUCTIONS FOR USE
56091234 - Nilfisk Liberty SC60
ENGLISH - A
C+
B+
A - 19