Nilfisk Liberty SC60 Instrucciones De Uso página 36

A - ENGLISH
RUN ROUTE, AUTONOMOUS MODE - CONTINUED
11 Verify the machine is cleaning correctly. Press Start/Pause Button
(33) to pause the route and adjust solution or scrub settings.
To continue the route press Start/Pause Button (33) again.
Monitor the side blades and rear squeegee during the first
few minutes of running the route to ensure they are properly
adjusted and not trailing water.
12 If the machine is paired with a mobile device it will receive an
update when a route is complete.
13 If the machine encounters an issue it will send a message to the
mobile device "Robot Requires Assistance" along with an image
from the front camera to aid in locating the machine.
14 After the route has completed go back to the machine and enter
your 4-digit PIN 1337 to access the machine.
15 The display will show the route and what areas were "Cleaned"
and "Not Cleaned".
a. The machine may have had to navigate around people or
new obstacles so the area cleaned may not match up perfectly
with the trained route.
b. If consecutive routes were run then pressing the left or right
arrows allows for review of those routes.
16 Press "Done" to exit.
A - 36
INSTRUCTIONS FOR USE
Nilfisk Liberty SC60 - 56091234 11/2020