Publicidad
Idiomas disponibles
Idiomas disponibles
Installing and Removing the Battery Pack from
the tool
Warning! Make certain the lock-off button is
engaged to prevent switch actuation before
removing or installing battery.
To install battery pack (Fig. C)
● Insert battery pack firmly into tool until an audible click is
heard as shown in figure C. Ensure battery pack is fully
seated and fully latched into position.
To remove battery pack (Fig. D)
● Depress the battery release button (4b) as shown in
figure D and pull battery pack out of tool.
Storage hook (Optional extra) (Fig. E)
Warning! To reduce the risk of serious personal
injury, place the forward/reverse button in the
lock-off position or turn tool off and disconnect
battery pack before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Warning! To reduce the risk of serious personal
injury, ensure the screw (8) holding the storage
hook is secure.
Note: When attaching or replacing the storage hook (7), use
only the screw (8) that is provided. Be sure to securely tighten
the screw.
To move the storage hook, remove the screw (8) that holds
the storage hook (7) in place.
The Storage hook (7) can be be attached by sliding the hook
into the slots (9) on either side of the tool using only the screw
(8) provided, to accommodate left- or right- handed users. If
the hook is not desired at all, it can be removed from the tool.
Note: Various trackwall hooks and storage configurations are
available.
Please visit our website www.stanleytools.eu/3 for
further information.
Assembly
Warning! Before assembly, remove the battery
from the tool and make sure that the saw blade
has stopped. Used saw blades may be hot.
Fitting the saw blade (Fig. F)
● Hold the tool away from the body
● Rotate the blade clamp collar (5) in the direction shown
in figure F.
● Insert the shank of the blade (10) fully into the blade
clamp collar (5).
(Original instructions)
● Release the blade clamp collar (5) to lock the blade
into position.
Note: The blade can be installed with the teeth up to assist in
flush cutting.
Removing the saw blade
Warning! Burn hazard: Do not touch the blade
immediately after use. Contact with the blade
may result in personal injury.
● Rotate the blade clamp collar (5) to the release position
● Remove blade (10)
Lock-off button
The tool is equipped with a switch lock-off feature to prevent
unintentional operation.
● To lock: push the lock-off button (2) to the locked position
.
● To un-lock: push the lock-off button (2) to the un-locked
position
.
Switching on and off
The variable speed on/off switch offers a choice of speeds for
greatly improved cutting rates in various materials.
● To switch the tool on, squeeze the variable speed on/off
switch (1).
● To switch the tool off, release the variable speed on/off
switch (1).
Sawing
● Always hold the tool with both hands.
● Let the blade run freely for a few seconds before starting
the cut.
● Apply only a gentle pressure to the tool while performing
the cut.
● If possible, work with the shoe (3) pressed against the
workpiece. This will improve tool control and reduce
tool vibration, as well as prevent the blade from
being damaged.
Hints for optimum use
Sawing wood
● Clamp the workpiece securely and remove all nails and
metal objects.
● Holding the tool with both hands, work with the shoe (3)
pressed against the workpiece.
Flush cutting
The compact design of the reciprocating saw motor housing
and pivoting shoe permit close cutting to floors, corners and
other difficult areas.
To maximize flush cutting capabilities:
ENGLISH
23
Publicidad
