cecotec CONGA ROCKSTAR 1500 ULTIMATE ERGOFLEX Manual De Instrucciones página 40

ENGLISH
3. PRODUCT ASSEMBLY
Vacuuming tube and suction base assembly
To install the suction base into the vacuuming tube, align both of them making sure the tab on
the suction base matches the guides on the tube, and introduce one into the other until they
are firmly fixed. To disassemble them, press the suction base release button and pull from the
vacuuming tube while you hold the suction base.
Warning
When assembling these 2 parts, make sure the handle and the brush are facing the same
direction.
Use the Flex tube to reach and vacuum dirt from the most inaccessible zones. Press the Flex
button to bend the tube.
Fig. 2/2.1/2.2
Battery assembly
Introduce the battery in the slot located in the handheld vacuum cleaner following the guides.
Once it is introduced, it will click into place. Move it slightly to ensure it is properly assembled
in place.
Note
Take the battery out and store it in a safe, dry place if the device is not going to be used in a
long period of time.
Fig. 3
Following the below illustration, keep the vacuuming tube vertically, align the tab on the
vacuuming tube with the guides in the handheld vacuum cleaner and introduce the tube.
Fig 4.
4. OPERATION
Wall charging base installation
- First, fix the wall charging base. To do so, we recommend you place a protective film
(not included) on the wall's surface. Then, put the charging base on the wall and make 3
corresponding to the holes to be drilled in order to fix the base. Consider the height of the
installation, it is important that suction base rests on the floor to avoid the charging base
from holding all the vacuum cleaner's weight. Make 3 holes on the wall and fix the charging
base with the supplied M4 x 32 nuts and screws.
- It must be installed at 102,5 mm from the floor.
CONGA ROCKSTAR 1500 ULTIMATE-ERGOFLEX
40