cecotec CONGA ROCKSTAR 1500 ULTIMATE ERGOFLEX Manual De Instrucciones página 41

- Make sure that the charging base is securely fixed on the wall, place the vacuum cleaner on
the charging base as shown in figure 5 by putting the vacuum cleaner's charging terminals
into contact with the charging base's ones (plastic tab).
- Once the wall charging base is installed, the charging port must be connected to the power
adapter, and then the device can be charged by sliding it from top to bottom into the wall
charging base.
Fig. 5
Charge and display
- When the battery percentage is 20 % or below, the device will automatically enter
low consumption mode. It is recommended to charge the device when it reaches this
percentage.
- The battery must be charged on the fast charge base while connected to the device.
Connect one of the ends of the power adapter to the power supply and the other to the
fast charge base.
Fig. 6
- During charging, the charge light indicator will turn on red and the display will show the
current charge percentage. When the device is fully charge, the battery indicator will turn
green, and the display will show 100 %.
Fig. 7
- It can also be charged without the fast charge base when the battery is installed in the
device or when it is outside. Connect the adapter and connect the other end to the battery,
paying attention to the direction. Once it is properly connected, the charge light indicator
will turn on red and will turn green once the charge is competed.
Fig. 8
Fig. 9
Using the handheld vacuum cleaner
1. Press the On/off button to turn the device on and off.
2. Press the speed control dial to select the device operating speed: Low, Medium, High, or
Smart. The device will operate in ECO mode by default and will display "LOW". The battery
percentage and sync will also be displayed.
3. Press the speed control dial to set the device at medium speed. "MED" will be displayed
on the screen. The battery percentage and sync will also be displayed. 2/3 of the opening
radio will be shown (vacuuming).
4. Press the speed control dial to set the device at high speed. The screen will display "HIGH".
The battery percentage and sync will also be displayed. The vacuuming opening radious
will be completely shown.
5. Press the speed control dial to set the device at Smart speed. Under this mode, the device
will automatically adjust suction power according to the concentration of dust and the
type of surface. The screen will display "AUTO. The battery percentage and sync will
CONGA ROCKSTAR 1500 ULTIMATE-ERGOFLEX
ENGLISH
41