cecotec CONGA ROCKSTAR 1500 ULTIMATE ERGOFLEX Manual De Instrucciones página 45

7. ERROR CODES
Code Problem
E1 The device turns off and does not
charge
E2 The device does not charge
E2 The device does not charge
The device turns off
E3 The device turns off and displays E3
E5 The device turns off and displays E5
E6 The device turns off and displays E6
E9 The device turns off and displays E9
E7 The device stops working or does not
turn on and shows E7
E8 The device turns off and displays E8
High-efficiency The device stops working or does not
filter indicator turn on
blinks Fig. 24
The indicator Works normally
blinks Fig. 23
The indicator Works normally
blinks
The indicator Long brush and motor stop working
blinks Fig. 25
Note:
The low battery warning will disappear when the charger is disconnected.
Low battery error (excluding shut down due to low battery), will stop after 6 seconds. If not,
press the on/off button to stop it.
Communication or NTC error: It will stop after 60 seconds.
Cause
Short-circuit
The charger's voltage is below
36.3 V
The charger's voltage is below 32.1
V
Low battery
The motor short-circuits when
battery is low
Main motor overload (second level)
Main motor overload
Temperature too high or low
Battery fault (first level)
NTC error (thermistor short-circuit)
High-efficiency filter not installed
The dust tank or the inlet filter is
blocked
Long brush full of hair
Blocked long brush
CONGA ROCKSTAR 1500 ULTIMATE-ERGOFLEX
ENGLISH
45